自動攪拌車的發動機一般都是搭配馬力比較大的，不同的司機駕駛同一輛攪拌車，有的司機總說車輛上坡沒勁，油耗還一直居高不下，這是怎么回事呢？
The engine of automatic mixer is generally matched with large horsepower. Different drivers drive the same mixer. Some drivers always say that the vehicle is boring uphill, and the fuel consumption has been high.
如果攪拌車定期的更換機油、機油濾芯、柴油濾芯、空氣濾芯的話，那應該就是一下幾個問題：
If the mixer regularly changes the oil, oil filter, diesel filter and air filter, it should be the following problems:
增壓器損壞，如果增壓器葉輪軸匡動，罐內有機油基本斷定已經損壞，另外要檢查管道，氣泵打壓用泡沫水檢查增壓機和出氣管接頭橡膠卡扣處是否有漏氣現象。
If the turbocharger blade shaft is damaged, the oil in the tank is basically damaged. In addition, it is necessary to check the pipeline and air pump pressure with foam water to check whether there is leakage at the rubber buckle of the supercharger and outlet pipe joint.
檢查中冷器是否斷裂，同樣的方法氣泵打壓仔細檢查水箱前面中冷器是否有漏氣，調整氣門，定時按車輛的公里數值找人員來調整氣門間隙。
Check whether the intercooler is broken. In the same way, the air pump is pressed to carefully check whether the intercooler in front of the water tank is leaking, adjust the valve, and find professionals to adjust the valve gap according to the kilometer value of the vehicle.
更換達標的尿素，選擇車用尿素一定要買合格的產品，不要輕易改動尿素噴頭，有些攪拌車司機為了省錢，故意石子改裝尿素噴頭，有的人直接將插頭拔掉，不使用尿素。
Replace the standard urea, choose car urea must buy qualified products, do not easily change the urea nozzle, some mixing car drivers in order to save money, deliberately stone urea nozzle modification, some people directly unplug, do not use urea.
掛檔前推不到位，后拉不到底。有很多的車輛掛檔都是比較重的，很多時候還掛不到位，這種情況一般有以下一個原因：
The front push is not in place, and the back pull is not in the end. There are a lot of vehicles are relatively heavy gear, many times are not in place, this situation generally has the following reason:
掛擋桿或者球頭磨損，從掛檔下方一直到變速箱上面有很多個球頭，由于在平時開車過程中需要不斷的變更檔位，所以球頭比較容易磨損，發現匡動就要及時更換。
There are many ball heads from below the gear to the gearbox. Because in the usual driving process, the gear needs to be constantly changed, so the ball head is easier to wear and tear. It is found that quanqu will be replaced in time.
變速桿拉線，現在很大一部分專用車采用變速箱拉線設計，拉線使用時間長了就會起刺變長，就會導致掛檔費勁甚至掛不上檔，發現拉線問題要及時更換。等等。
The gear lever pull line, now a large part of special vehicles use the gearbox pull line design, the pull line used for a long time will thorn and become long, it will lead to difficult or even can not hang up the gear, found that the pull line problem should be replaced in time. And so on.
How can a mixer be boring on a hill? That's the reason. If you want to know more, go to m.top2010.cn!
上一篇：新買的水泥自動攪拌車如何使用才能效率更久？
下一篇：自動攪拌車的傳動體系及攪拌體系如何？
