【1】、攪拌車液壓傳動系統液壓油的壓力、油量、油質、油溫應達到規定要求，無滲漏現象。
【1】 The pressure, oil quantity, oil quality and oil temperature of hydraulic oil in the hydraulic transmission system of mixer truck shall meet the specified requirements without leakage.
【2】、攪拌運輸中，裝載混凝土量不能超過允許裝載質量。
【2】 During mixing and transportation, the amount of concrete loaded shall not exceed the allowable loading quality.
【3】、攪拌車露天停放時，裝料前應先將攪拌筒反轉，讓筒內的積水和雜物排出。裝料前，更好先向通內加少量水，使進料流暢，防止粘料。
【3】 When the mixer truck is parked in the open air, the mixing drum shall be reversed before loading to discharge the ponding and sundries in the drum. Before loading, it is best to add a small amount of water to the Tong to make the feeding smooth and prevent sticking.
4】、攪拌車行駛中，接長的卸料槽必須翻轉后固定在卸槽上，再轉至與車身垂直部位，用銷軸與機架固定，防止由于不固定而引起擺動，打傷行人或影響車輛運行。
4】 During the driving of the mixer truck, the extended discharge chute must be turned over and fixed on the discharge chute, then turned to the position perpendicular to the vehicle body, and fixed with the frame with a pin shaft to prevent swinging caused by non fixation, injuring pedestrians or affecting the operation of the vehicle.
【5】、攪拌車通過橋、洞、庫等設施時，應注意通過高度及寬度，以免發生碰撞事故。特別需要注意的是現在的四軸罐車的長度很長，在通過橋洞高度接近極，長長的車身是下圓弧路面上的一道弦，能通過的高度會降低。
【5】 When the mixer truck passes through bridges, holes, warehouses and other facilities, pay attention to the passing height and width to avoid collision accidents. It should be noted that the length of the current four axle tank car is very long. When the height of passing through the bridge opening approaches the limit, the long body is a string on the lower arc Road, and the passing height will be reduced.
This paper is composed of cement self loading mixer http://m.top2010.cn Friendship and dedication. For more relevant knowledge, please click: sincere attitude. We will provide you with comprehensive service. More relevant knowledge will be offered to you one after another. Please look forward to it
上一篇：自上料攪拌車的設計要怎樣發展？
下一篇：砼攪拌車在進行發動機維修需要注意是什么？
